General Instructions
See separate doweling, laminating, and patching instructions for more specific instructions. CSI format specifications are available.

Surface Preparation and Use
Use gloves, wear eye protection, and avoid skin contact. When grinding cured patches or non-structural joints, wear a dust mask. Substrates must be completely dry and dust-free. Mix only the amount of Gripstone which can be used in 10 minutes. Avoid stressing joint before complete cure of Gripstone. Mask areas which must be kept free of Gripstone. Clean tools with toluene or xylene. Use caution, these solvents are flammable. Ensure local ventilation.

Mixing Instructions
All materials should be at or above 45°F. Combine the two ingredients at the following weight ratio: two parts hardener to 98 parts Gripstone. Mix thoroughly. Prepare only as much material as can be immediately used.

Temperature Dependency
Temperature will affect the working properties of the material. Approximately every 10°F results in doubling the speed of cure. Therefore, at 85°F set time is cut in half, at 65°F the set time is doubled.

Coverage
Approximately 30 square feet per gallon when applied at 50 mils (1/16th of an inch). 231 cubic inches per gallon when mixed at 50 mils (1/16th of an inche). 231 cubic inches per gallon.

Availability

Packaging and Storage
Gripstone is available in quarts and gallons. Gripstone has a shelf life of six months at 70°F in unopened containers. Under no circumstances should the hardener be allowed to get above 100°F.

Warranty

This warranty is limited to replacement of defective material and freight charges to destination only. Bonstone Materials Corp. is not responsible for consequential damages.

Maintenance

Designed for interior application in areas inaccessible to maintenance procedures.

Technical Service

Specification Service

Specifications on file
Development of proposed specifications for special projects.

Lab Service

Spectrophotometric color matching is available.
Sample patches can be made on stone forwarded to lab.

This information is furnished without warranty, representation, inducement, or license of any kind, except that is is accurate to the best of Bonstone Material Corporation's (BMC) knowledge or obtained from sources believed by BMC to be accurate, and BMC does not assume any legal responsibility for use of reliance upon same. User must determine if the product, process, or information described is suitable to the intended application. Before using any chemical, read its label and Material Safety Data Sheet.

<Back | Top | Home